Views: 0 Author: Site Editor Publish Time: 2026-11-16 Origin: Site
Brief Summary
Many buyers request DLC diamond-like carbon coating by default, believing it is the best scratch and moisture-resistant coating. In reality, DLC brings intrinsic absorption in infrared bands and sacrifices part of optical transmission. Coating design is a balancing act: AR anti-reflection, DLC hard protection and stray light suppression rarely peak at the same time. Priorities must be set based on operating conditions.
Table of Contents
1.DLC delivers strong ruggedness but comes with inherent infrared absorption
2.Single-layer and broadband multilayer AR coatings have distinct pros and cons
3.Coating recipes directly impact ghost formation and stray-light performance
4.Coating stacks need customization based on the end operating environment
1. DLC delivers strong ruggedness but comes with inherent infrared absorption
DLC features high hardness and excellent resistance against sand abrasion, humidity and salt spray, ideal for vehicle-mounted, coastal and outdoor long-term deployment. However, DLC absorbs radiation within the 8–12 μm window. Poorly controlled film thickness reduces system transmission and worsens NETD. Applying DLC unnecessarily in dry indoor labs only wastes system sensitivity.
2. Single-layer and broadband multilayer AR coatings have distinct pros and cons
Basic AR coatings target high transmission at one band. Broadband multilayer stacks cover wider spectral ranges, but thicker films carry higher internal stress and risk delamination after thermal cycling, with higher fabrication costs.
3. Coating recipes directly impact ghost formation and stray-light performance
Pursuing the lowest surface reflectance may trigger constructive reflection at certain incident angles and introduce new ghosts. Optical designers match coating recipes with lens layouts to suppress both surface reflection and ghosting, especially for wide-FOV optics.
4. Coating stacks need customization based on the end operating environment
For indoor constant-temperature inspection, prioritize high-transmission broadband AR. For coastal, dusty outdoor environments, adopt DLC plus optimized underlying AR to accept limited transmission loss for superior durability. Extra passivation layers may be required for chemical vapor exposure.
Conclusion
A coating is not “better” just because it is advanced. It should match your working environment. When reviewing coating specifications, check not only coating type but also measured spectral transmission curves and environmental aging reports. We can recommend film stacks that strike a good balance among transmission, ruggedness and ghost control and avoid over-engineering or insufficient protection.